我公司是专业的脱硫塔除雾器生产厂家,位于河北省衡水市枣强县,交通便利。
公司主要生产销售:除雾器、平板式除雾器、脱硫塔除雾器、pp除雾器、烟道内水平除雾器、玻璃钢除雾器、环保设备、烟气脱硫、脱硝设备等产品。
直销电话: Q
果洛脱硫除雾器冲洗水管选型技术要求
1、除雾器机械要求
1.1除雾器冲洗水管能够满足正常工作的压力要求,保证正常的使用寿命。
1.2除雾器冲洗水管能够满足吸收塔内的使用工况,包括微酸性气体环境,以及含部分颗粒物的烟气。
1.3除雾器冲洗管、喷嘴及构件应能在吸收塔腐蚀、热和磨损浆液条件下防止断裂和腐蚀。管道应易于拆卸和组合。
1.4供方应确保烟气温度在80摄氏度时和短时(10分钟)90摄氏度除雾器冲洗水管不会损坏。
1.5喷嘴设计应与管道连接牢固并易于拆卸。除雾器喷嘴与管道应长期牢固地运行在实际活荷载下。
1.6所有组件的设计,包括除雾器冲洗水母管、支管及和喷嘴的链接构件应有足够的强度,能够承受除雾器重新水泵的压力,并能防止实际运行条件下的振动。
2、除雾器材料要求
2.1除雾器管道、法兰采用玻璃钢FRP,喷嘴采用PP-R材质。
2.2垫圈采用EPDM。
2.3所有法兰采用HG20592标准。
2.4除雾器材料性能完全满足使用工况要求。
果洛脱硫除雾器的冲洗水量
选择除雾器冲洗水量处理需要满足除雾器自身的要求外,还需要考虑系统水平衡的要求有些条件下需采取大水量短时间冲洗,有时则采用小水量长时间冲洗,具体冲洗水量需由工况条件确定,一般情况下除雾器断面上舜时冲洗水量约2-4.5m3/h
Working principle of FRP mist eliminator
The principle of the FRP mist eliminator is the gravity and the inertia impact. When the mist gas is passed through the mist eliminator at a certain speed, it will collide with the internal structure of the demister and attach to its surface. Fogging on the surface of the internal structure of the foggy Foger is gradually aggregated by diffusion and gravity. When the weight reaches a certain level, it will be separated from the internal structure of the demister.
Contact phone: Q